Ventilation FansRange Hood

GE JVX5305DJBB Ventilation Fan Manual

Setup, everyday use, maintenance and troubleshooting for the 139 CFM range hood, with verified specifications.

  • Airflow139 CFM
  • Efficacy3.4 CFM/W
  • Duct size3.25 × 10 in.

About the GE JVX5305DJBB

The GE JVX5305DJBB is a 139 CFM range hood certified under the ENERGY STAR program.

It is rated to move 139 cubic feet of air per minute. It connects to a 3.25 × 10 in. rectangular duct.

Fan efficacy is 3.4 CFM per watt, which means the motor draws roughly 41 W at 139 CFM.

Specifications

GE JVX5305DJBB specifications
BrandGE
Model numberJVX5305DJBB
Fan typeRange Hood
Rated airflow139 CFM
Fan efficacy3.4 CFM/W
Number of speeds2
Duct connection (rectangular)3.25 × 10 in.
Integrated lightNo
ENERGY STAR Most EfficientNo

Safety information

  • Turn off power at the circuit breaker before installing, wiring or cleaning the fan, and confirm it is off with a non-contact voltage tester.
  • Install and wire the fan in accordance with the instructions and local electrical and building codes. If you are unsure, hire a licensed electrician or HVAC contractor.
  • Always duct the fan to the outdoors. Never terminate exhaust in an attic, crawl space, soffit vent or wall cavity — trapped moisture and grease cause mold, rot and fire risk.
  • Never leave cooking unattended, and keep grease filters clean — grease buildup in the hood or duct is a fire hazard. In a grease fire, turn off the burner and smother the flames with a lid or baking sheet; never use water. If the fire does not go out immediately, leave the house and call the fire department.
  • Do not use the fan to exhaust explosive or flammable vapors.

Installation and first-time setup

  1. Confirm the mounting height

    Install the hood at the height above the cooktop specified in the installation manual — commonly 24–30 in. — to balance capture and head clearance. Gas cooktops often need more clearance than electric.

  2. Check the airflow

    Building codes typically require at least 100 CFM for kitchen exhaust. This hood is rated at 139 CFM; heavy cooking or high-output gas burners benefit from more capture.

  3. Route the duct

    Connect the 3.25 × 10 in. rectangular duct with smooth metal duct, sealed with foil tape. Avoid plastic or foil flex duct, keep elbows to a minimum, and terminate at a wall or roof cap with a backdraft damper.

  4. Mount and wire

    Secure the hood to studs or blocking with the supplied hardware and connect power as the wiring diagram shows. Install the grease filters before first use.

  5. Test

    Run each speed, and check outdoors that the damper opens.

Using your range hood

Getting the best capture

Switch the hood on a few minutes before you start cooking so an air current is established, use the rear burners when possible because they sit directly under the hood, and leave it running for 10–15 minutes after cooking to clear lingering moisture and odors.

Care and maintenance

WhenWhat to do
Every monthRemove the metal grease filters and wash them in hot, soapy water or in the dishwasher if the manual allows. Dry before reinstalling.
Every 3–6 monthsReplace the charcoal filter if the hood is installed in recirculating mode.
Every 3 monthsWipe grease from the hood interior, fan housing and underside with a degreasing cleaner.
Every yearCheck outdoors that the damper flap opens freely and the exterior cap is clear of lint, nests and debris.
Every few yearsInspect accessible duct runs for disconnected joints, crushed sections or condensation.

Troubleshooting

Weak airflow and excess noise are almost always caused by the duct system rather than the fan. Turn off power at the breaker before removing the grille or touching the motor.

ProblemPossible causeWhat to try
Fan runs but moves little airDamper stuck closed; duct crushed, disconnected or too long; dirty grille or filter.Check the exterior damper and cap, inspect the duct, and clean the grille or filters.
Louder than expectedRestrictive or undersized duct; loose grille; housing not secured.Use duct at least as large as the collar (3.25 × 10 in. rectangular), tighten the grille and mounting screws.
Rattling or flapping soundBackdraft damper fluttering in wind; loose duct.Secure the duct and check that the damper closes fully; a wall cap with a better damper may help.
Water dripping from the grilleCondensation in an uninsulated duct; duct sloped back toward the fan.Insulate the duct in unheated spaces and slope it toward the exterior.
Fan will not startBreaker off; switch or timer failed; motor plug loose in the housing.Check the breaker, test the switch, and with power off confirm the motor is plugged into its receptacle.
Cold drafts from the fan when offDamper not closing; unsealed housing.Free or replace the damper and seal around the housing.
Smoke and odors escape the hoodFan started too late; front burners used; filters clogged.Start the hood earlier, cook on rear burners, use a higher speed and clean the filters.

Energy use and running costs

Ventilation fan certification lists airflow and efficacy rather than annual energy use. From 139 CFM at 3.4 CFM/W, the GE JVX5305DJBB draws roughly 41 W. The table estimates yearly use at an average electricity price of $0.17 per kWh.

ScenarioPowerEnergy per yearCost per year
Cooking, 1 h/day41 W14.9 kWh$2.54

The motor is only part of the cost: every cubic foot exhausted is replaced by outdoor air that must be heated or cooled. Run the hood while cooking and for 10–15 minutes afterward, then switch it off.

Frequently asked questions

How many CFM is the GE JVX5305DJBB?

It is rated at 139 CFM.

What size duct does the GE JVX5305DJBB need?

It has a 3.25 × 10 in. rectangular duct connection. Use duct at least that size all the way to the exterior cap; reducing it cuts airflow and raises noise.

How much electricity does the GE JVX5305DJBB use?

With an efficacy of 3.4 CFM/W it draws roughly 41 W at 139 CFM. Running one hour a day costs about $2.54 a year at $0.17/kWh.

Does the GE JVX5305DJBB have a light?

No. The certified configuration does not include a light.

Can the GE JVX5305DJBB vent into the attic?

No. Range hood exhaust must be ducted to the outdoors through a wall or roof cap with a damper. Venting into an attic or soffit deposits grease and moisture in the building.

Sources and disclaimer

Specifications on this page come from the ENERGY STAR certified ventilation fans dataset published by the U.S. Environmental Protection Agency (record certified July 28, 2022), retrieved October 7, 2026.

The setup, operating, maintenance and troubleshooting guidance is written by ManualHarbor's editors for this specific product type and configuration. It is an independent guide — not a reproduction of the manufacturer's manual — and ManualHarbor is not affiliated with GE. Always follow the safety instructions, installation requirements and warranty terms supplied with your unit, and contact GE or an authorized service provider for warranty repairs and replacement parts.

Running-cost figures use assumed U.S. average utility prices and are estimates for comparison only. See our editorial methodology for details.